DIY Wooden Fence Cost Calculator in Wyoming (2026)
A fence in Wyoming has to be built for wind first, and everything else after that. The material bill for a 150 linear ft, 6 ft privacy fence comes to roughly $1,450–$2,950 for pressure-treated pine, $2,950–$4,900 for cedar, or $4,400–$6,900+ for redwood. Open exposure and strong gusts can put a lot of force on a privacy fence, so deep post holes, enough concrete, and sturdy gate framing are essential. In many parts of the state, dry air and strong sun also age lower-grade wood faster than people expect, so sealing pine is important if you want it to last.
Wyoming yards can also have rocky or compacted ground, which makes digging a bigger part of the budget than the fence itself suggests. A rented auger often pays off on a full fence run. State sales tax is relatively low, so checkout totals stay a bit lighter than in high-tax states. Before you build, check local permit requirements and verify your property line, especially on larger lots where boundaries may not be obvious from existing landmarks.
Fence Length
Total Length: 150 linear ft
Quality Tier
Materials
Cost Breakdown
| Material | Qty | Unit Price | Total |
|---|---|---|---|
| Posts & Footings | |||
| Fence Posts (4x4x8) | 21 post | $23.97 | $503.37 |
| Concrete Mix (Fast-Setting) | 42 bag | $7.97 | $334.74 |
| Rails | |||
| Fence Rails (2x4x8) | 8 pack | $30.28 | $242.24 |
| Pickets & Panels | |||
| Fence Pickets / Panels (6 ft. H) | 360 picket | $4.00 | $1,440.00 |
| Fasteners | |||
| Fence Screws (Exterior Coated, 1-5/8 in.) | 4 pack | $26.97 | $107.88 |
| Materials Subtotal | $2,628.23 | ||
| Sales Tax | $105.13 | ||
| Total | $2,733.36 | ||
| $18.22 per linear ft | |||
* Estimates are approximate and based on national average material prices adjusted for your state. Actual costs may vary depending on local supplier pricing, project complexity, and contractor rates.
Shopping List for Install a Wooden Fence (2026)
- Fence Posts (4x4x8)Mid21 post
3.5 in. x 3.5 in. x 8 ft. Redwood Corner, End Fence Wood Post
Out of stock? Search for similar products
3.5 in. x 3.5 in. x 8 ft.; rough-sawn redwood; naturally rot- and insect-resistant; suitable for burial 2 ft below grade, 6 ft above
- Concrete Mix (Fast-Setting)42 bag
50 lb. bag; yields approx. 0.375 cu. ft. of mixed concrete; sets in 20–40 min; 4000 PSI at 28 days
- Fence Rails (2x4x8)Mid8 pack
Mendocino Forest Products 2 in. x 4 in. x 16 ft. Construction Common Redwood Lumber
Out of stock? Search for similar products
1.5 in. x 3.5 in. x 16 ft. each; construction common redwood; naturally rot-resistant; sold as 4-pack (~$7.57/rail)
- Fence Pickets / Panels (6 ft. H)Mid360 picket
Outdoor Essentials 19/32 in. D x 5-1/2 in. W x 6 ft. H Cedar Dog-Ear Fence Picket
Out of stock? Search for similar products
0.594 in. x 5.5 in. x 6 ft.; dog-ear top; actual face width 5.5 in.; above-ground rated; naturally rot-resistant cedar
- Fence Screws (Exterior Coated, 1-5/8 in.)4 pack
DECKMATE #8 x 1-5/8 in. Tan Star Flat-Head Wood Deck Screw (5 lb. / ~619-Piece)
1-5/8 in. length x #8 diameter; star drive; flat head; ACQ-compatible exterior coating; 5 lb. package (~619 screws)
Project Assumptions
- •Fence height is 6 ft (3 horizontal rails per section: top, mid, bottom).
- •Post spacing is 8 ft on center.
- •Posts are set in concrete footings.
- •Gates are not yet priced — gate and hardware costs scale with the number of gates needed.
- •Post caps are included on all posts.
- •No grading, removal of existing fence, or permit costs are included.
- •Coverage rates include a 10% waste factor.
What Affects Costs in Wyoming
Wyoming's wind load is the defining structural cost factor that distinguishes it from most other states. The high plains and mountain basins of Laramie, Rawlins, Cheyenne, and Casper see sustained average wind speeds that are among the highest for populated areas in the country. A 6-foot privacy fence in those locations is a significant wind sail, and the structural response — deeper post holes, wider concrete footings, shorter post spacing, heavier post dimensions — adds real cost per linear foot compared to a sheltered location.
Labor rates at 0.90× the national average are below baseline. Wyoming has a small construction labor pool relative to its land area, and contractor availability in rural areas is genuinely limited. In Cheyenne, Casper, and Gillette, contractor booking during peak season requires advance scheduling; in smaller communities, finding a specialized fence crew may require looking outside the immediate area.
Material costs in Wyoming are pushed up by the state's remoteness from major distribution centers. Lumber yards in Cheyenne draw from Denver supply lines; Casper from both Denver and Billings. Remote communities may be served by distributors operating on longer shipping cycles, and specialty materials like cedar or redwood may need to be ordered in advance rather than pulled off a shelf. Wyoming's low 4% sales tax partially offsets that freight premium.
Local Tips for Wyoming
For wind-exposed installations along the Wyoming Front Range and the open basins, go to 4-foot post depth as a minimum — not a maximum. Cheyenne and the Laramie Basin regularly see sustained winds above 30 mph with gusts well above 50, and fence posts set to standard depth in those locations have a limited lifespan measured in seasons rather than decades. Local contractors in wind-corridor cities routinely quote 4-foot post depth as their standard practice.
Time your installation for May through September. Wyoming winters can lock the ground by late October and freeze depths can reach 30–36 inches in the southern tier and more in the northern mountains. Spring thaw in the higher elevations takes time — Sheridan and Cody can see late frost through May. The early fall window (August–September) is often excellent: ground is workable, temperatures are moderate, and the harshest summer heat has passed.
Wyoming municipalities require permits in most cities. Cheyenne, Casper, and Laramie have permit requirements for residential fences with fees typically ranging from $50 to $75. Rural Wyoming counties are permissive — most do not require permits for residential fences on private property. Property line verification matters more in Wyoming than in many states: large lot sizes, long property frontages, and limited survey marker availability in rural areas mean the fence line can drift from the actual boundary without deliberate confirmation.
Frequently Asked Questions
How deep do fence posts need to be set in Wyoming, and does snow load matter?
Wyoming frost depth is typically 36 to 48 inches, and deeper in colder mountain communities. The standard 2 ft burial is usually inadequate for Wyoming. Aim for at least 36 inches and confirm the required depth with your local building department. Snow load matters less for a typical vertical privacy fence than frost and wind, but drifting snow and high winds absolutely increase stress on posts in winter — deep, well-concreted posts are the priority.
What fence material holds up in Wyoming's extreme temperatures and wind?
Wyoming's climate combines intense sun, strong winds, and severe winter cold. Cedar handles wide temperature swings better than PT pine for above-ground components, especially if protected with a UV-blocking stain. Vinyl can work well if you choose a product rated for both high UV and extreme cold — cheap vinyl risks brittleness in winter and degradation in intense sun. In Wyoming, though, post installation quality matters even more than surface material.